Andyco Posted December 21, 2019 Report Share Posted December 21, 2019 Can anyone tell me or send a link on how to lead weight the line tie in crankbait lips like the old Bagley DB3 Quote Link to comment Share on other sites More sharing options...
RayburnGuy Posted December 21, 2019 Report Share Posted December 21, 2019 I can't tell you how to do this exactly as the Bagley's were done, but I have weighted diving lips. This was done by using a piece of solid core solder and drilling a hole in the lip just large enough for the solder to fit in snugly. You then fit a short length of solder in the hole and brad it so it flattens out on each side of the lip. hope this helps..............Ben 1 Quote Link to comment Share on other sites More sharing options...
AZ Fisher Posted December 21, 2019 Report Share Posted December 21, 2019 https://www.tacklewarehouse.com/Storm_SuspenStrips_70_Strips/descpage-SSS.html These might work for you. I use them for weighting swimbaits all the time. Maybe under the lip or down the throat a little to get the nose down and a little deeper depth, hope this helps... Quote Link to comment Share on other sites More sharing options...
Andyco Posted December 22, 2019 Author Report Share Posted December 22, 2019 Ben do you have a photo of how you did yours Quote Link to comment Share on other sites More sharing options...
RayburnGuy Posted December 23, 2019 Report Share Posted December 23, 2019 (edited) This is the only picture I can find. It's not close to the line tie, but can be placed wherever you'd like. You can also use a larger piece of lead wire if you need more weight. Just drill the appropriate sized hole. Ben Edited December 23, 2019 by RayburnGuy 1 Quote Link to comment Share on other sites More sharing options...
