Kscatman76 Posted February 4, 2020 Report Share Posted February 4, 2020 have any of you guys made a mold modification to allow you to make swing jigs with the Fastach style? I'm thinking about doing this but wondered if anyone had pictures of a mold or guidance on it? thanks, travis Quote Link to comment Share on other sites More sharing options...
rustedhook Posted February 13, 2020 Report Share Posted February 13, 2020 This is an old football head mold. The first thing I did was to pour a head with no hook so I could place back in the mold(put a little oil on it) to stop the JB Weld from getting in the head cavity. I drilled a whole on both sides of the mold just big enough for the clip end. I didn't drill right up to the head as to leave a little of the hook area. Filled the hook area on both sides with JB weld. I over filled just a little and then let the JB weld almost set and then cut it level to the mold surface. Its best to put a film of oil on the razor blade so the JB won't stick to it. Use a little cotton in the whole to make the clip lay as shown and then close the mold tight to make an imprint in the JB weld. This was done to the 1/2 and 3/4 oz. I used a number 3 clip. Hope this helps. 1 Quote Link to comment Share on other sites More sharing options...
rustedhook Posted February 13, 2020 Report Share Posted February 13, 2020 Just now, rustedhook said: Well don't know where the picture went. 1 Quote Link to comment Share on other sites More sharing options...
rustedhook Posted February 13, 2020 Report Share Posted February 13, 2020 Quote Link to comment Share on other sites More sharing options...