Bassmaster Rick Posted August 31, 2020 Report Share Posted August 31, 2020 Hey Guys. I'm making Senkos using the Angling Ai core shot mold. Nice mold. I've noticed that I'm getting some small flat spots in the outer plastic shoot. I don't think the fish are gonna notice it but I do. I'm injecting my first shot at 325-340 degrees and the second shot a little hotter as recommended. I let the first shot sit/set for 7-8 minutes or more before pulling the rods out. And then injecting the second shot. Any advice? Or should I not worry about it. Thanks. Quote Link to comment Share on other sites More sharing options...
Jig Man Posted August 31, 2020 Report Share Posted August 31, 2020 You may need to hold some pressure after the second shoot and overfill to allow for shrinkage. 1 Quote Link to comment Share on other sites More sharing options...
wallyc14 Posted August 31, 2020 Report Share Posted August 31, 2020 Shot cooler that should stop the denting. I would shoot it around 320 and knock another 10° off that if it still keeps Denting you’ll find the Sweet Spot. 2 Quote Link to comment Share on other sites More sharing options...
