Rbertalotto Posted November 4, 2020 Report Share Posted November 4, 2020 I'm just getting involved with surf casting big baits for Strippers. Wanted to try making my own lures. My lathe came in today along with a ton of lure making stuff....Can't wait to startt and then wet them! Quote Link to comment Share on other sites More sharing options...
Rbertalotto Posted November 4, 2020 Author Report Share Posted November 4, 2020 I had this roll around cabinet in the corner of the shop for years. I was concerned that at 6'2" tall , it would be too low. When the lathe arrived I couldn't believe my luck and how it fit perfectly bolted to the two rails. PERFECT! The lathe runs extremely smooth. Bought it on Amazon for around $250. 1 Quote Link to comment Share on other sites More sharing options...
Vodkaman Posted November 4, 2020 Report Share Posted November 4, 2020 (edited) My guess is that you are a member of Stripers online, if not then you should be. Both TU and Stripers will be very useful to you. No need to join just one. Dave Edited November 4, 2020 by Vodkaman Quote Link to comment Share on other sites More sharing options...
Rbertalotto Posted November 4, 2020 Author Report Share Posted November 4, 2020 Thanks Dave, yes I'm a member over there too. Hopefully this turns into a fun hobby. 1 Quote Link to comment Share on other sites More sharing options...
Big Epp Posted November 4, 2020 Report Share Posted November 4, 2020 I really enjoy turning lures on a lathe! It's neat watching the blank take shape as you use the different tools on it, very relaxing. Quote Link to comment Share on other sites More sharing options...
eastman03 Posted November 4, 2020 Report Share Posted November 4, 2020 Welcome here, lots of great resources. I've used a lathe for a few of the lures I make. Most of them are not symmetrical/cylindrical so I don't use it all the time. It is a great tool to have. Make sure to wear eye protection! Quote Link to comment Share on other sites More sharing options...
mark poulson Posted November 4, 2020 Report Share Posted November 4, 2020 (edited) That is a really neat setup! It's great when something like the bench/machine match happens. Enjoy, and post photos of what you make. For me, the key to wood turning is sharp tools, and a tool rest that is close to the work piece, so you don't risk a tool catching and flipping out of your hand. Learn to sharpen your tools, which isn't hard, and you'll have a great time. Edited November 4, 2020 by mark poulson Quote Link to comment Share on other sites More sharing options...
Rbertalotto Posted November 4, 2020 Author Report Share Posted November 4, 2020 I bought a wet stone grinder system and a set of jigs to hold the tools for sharpening at the proper angles. My father used to say...."A dull tool is no tool!" 1 Quote Link to comment Share on other sites More sharing options...