Ed Brabant Posted April 29, 2021 Report Share Posted April 29, 2021 I have a 4 cavity hand pour senko mold. I took the mold to work and talked to one of the guys in our machine shop and had him cut a slot in the mold faces .50 wide and .010 deep right in the middle of the bait. Then before I pour I cut fine nylon screen just a bit under .50 and about 4" long. I then place the cut screen in one half the side with guide pins up then place the other side on clamp and pour. When I demold the baits the look like ammo on a belt. Cut the screen close to the bait. Then when I fish them wacky it's almost impossible to rip the hook thru. Because it's a hand pour no flash at all. I can even pour them with out the screen. Some I have to trim the little bit of flash off. 1 Quote Link to comment Share on other sites More sharing options...
