njbass Posted December 4, 2004 Report Share Posted December 4, 2004 I know i have asked a lot of questions, but i am real interested in this and i cant seem to get this two part down I have tried at least four times to get this but everytime, i eiter boke it trying to get it a part, or when i do get it a part(without braking) There are bubbles in the mold part of the top layer. Does anyone have any suggestions? Thanks a lot Jake Quote Link to comment Share on other sites More sharing options...
finlander Posted December 5, 2004 Report Share Posted December 5, 2004 It's been two years since I did mine. But there was a tutorial on making them here at one time. I know the first half had to set up and dry before pouring the 2nd half. And the master needed to be covered in Vaseline so it would release from the plaster. And toothpicks, oops no, bolts were used as guide pins to line up the two halfs when it comes time to pour the plastic. If you search the forum you will find LOTS of questions on mold making, and alot of answers too. Read on! Quote Link to comment Share on other sites More sharing options...
Senkosam Posted December 5, 2004 Report Share Posted December 5, 2004 NJ, read the tips in the tutorial. If you still have a problem, e-mail me. If the mold breaks, one side wasn't hard enough or the edge far enough away from the cavity. The foil idea works! http://bassresource.com/fishing/pouring_plastic_worms.html Sam Quote Link to comment Share on other sites More sharing options...
