threadfin Posted May 28, 2022 Report Share Posted May 28, 2022 Hi folks, Newbie to the forum here. I am getting a couple of slow pitch jig molds and need to make wire harnesses, like the one in the pic. The wire is 1mm / 0.041". These are for my own use, so don't need to make hundreds at a time! Would be most grateful for any recommendations. Cheers, Quote Link to comment Share on other sites More sharing options...
TerryF2858 Posted May 29, 2022 Report Share Posted May 29, 2022 try the utube videos from this guy he has some good homemade fixtures Engineered Angler Lures Quote Link to comment Share on other sites More sharing options...
threadfin Posted May 30, 2022 Author Report Share Posted May 30, 2022 Thanks I'll see if there is anything that will do the job! Quote Link to comment Share on other sites More sharing options...
cadman Posted June 7, 2022 Report Share Posted June 7, 2022 You can also try round bend pliers, which would be the most cost effective way to go if you are only making several. 1 Quote Link to comment Share on other sites More sharing options...
OIR Posted June 8, 2022 Report Share Posted June 8, 2022 1 Quote Link to comment Share on other sites More sharing options...
mark poulson Posted June 11, 2022 Report Share Posted June 11, 2022 On 6/8/2022 at 2:38 PM, OIR said: Really well done! Quote Link to comment Share on other sites More sharing options...
marley.roman96 Posted August 9, 2022 Report Share Posted August 9, 2022 (edited) Hi there! I usually use round bend pliers, and it works well for me. Edited August 9, 2022 by marley.roman96 Quote Link to comment Share on other sites More sharing options...
Riverchicken Posted December 11, 2023 Report Share Posted December 11, 2023 I have bent wire by using a small nail in a vise and bending the wire around the nail. Quote Link to comment Share on other sites More sharing options...
