Sheffy Posted July 18, 2022 Report Share Posted July 18, 2022 Hi I recently snapped part of my rod and I was wondering if it was a fixable and if so how can I fix it any suggestions are very helpful thank you for your time. Quote Link to comment Share on other sites More sharing options...
Chris Catignani Posted July 18, 2022 Report Share Posted July 18, 2022 There is a technique that uses an inner stint and an outer sleeve for the repair... Here is a link to Ralph O'Quinn's article on the procedure: Rod Repair by Ralph O'Quinn 1 Quote Link to comment Share on other sites More sharing options...
Les Young Posted September 9, 2022 Report Share Posted September 9, 2022 I'd say you could use something like a nail , bigger wire etc sort of like a small dowel rod to slide inside & glue or epoxy inplace & then epoxy where it is joined back together & do a little thread work too & it would work pretty good. May not be a pretty as when new but a whole lot cheaper than buying a new one & wouldn't look that bad either. I'd give it a shot if it was mine for sure. Quote Link to comment Share on other sites More sharing options...
