DIY ZMan willowvibe

[Jinx]

Looking for a mold that kinda mimics the zman willow vibe. Of course I’ll be using a different blade technique. Just wanted some thoughts from the smart guys. Roughly 1/4 ounce. 

[21xdc]

There are 2 that I would consider needing minimal mods if any. 

 

https://store.do-itmolds.com/Round-Head-Jig-HHbrSz-18-14-38-12-58brHk-630-or-635brCollar-Barb_p_487.html

 

https://store.do-itmolds.com/Freestyle-JigbrMultiple-SizesbrHk-MultiplebrCollar-Wire-Holder_p_1294.html

[Jinx]

Thank you! That freestyle looks like the ticket! How would you modify it or could you possibly run a 3/0 spinner bait hook with wire form WEY375?

Edited Thursday at 04:14 PM by Jinx

[21xdc]

The first mold will take a heavier wire hook, But no eye ball sockets.

Second uses a smaller diameter hook and would need to be opened up some, Unless you like a light wire hook. I'm not a fan of light wire hooks on this type of technique.

Make sure you use a blade that does not interfere with the hook point as it lays down flat. It will interfere with your hook ups.  

I'm also not a fan of those inserts. 

 

Edited Thursday at 04:31 PM by 21xdc

[Jinx]

Thanks for the advice. I was looking at trying to use the same hook as some do with the poison tail jig mold but I don’t think that would be possible. I can still use mini blades though and keep the 90 degree hook

[21xdc]

I prefer the Eagle Claw L3886BP and modify mold to accept this hook. 

[Jinx]

Oh that’s nice. A little RTV over the old hole and that’ll be perfect! 

[21xdc]

Or you just clip off the tab... 

[Jinx]

This is true. File it off. 

[Brushhog Billy]

If you end up using the mold without eye sockets you can take them to a vice or hard piece of metal and tap the sides of the jig flat so you can glue your eyes on. I do this on some of my ball heads and it works well.

[Jinx]

Nice advice! Didn’t think of that