Psy Posted Tuesday at 04:05 AM Report Share Posted Tuesday at 04:05 AM After the holidays I'm going to contact my local waste management facilities and see what they say. I'm curious what other people do. Long story short, earlier this year I ordered some plastisol from Bait Plastics that was terrible. Loads of bubbles, but worse than that, it burns very, very quickly and easily. I have to add a good bit of heat stabilizer just to prevent it from scorching before it hits 350 degrees. And that's with very careful microwave usage, heating in small increments in ideal heating zones in the microwave. I just gave up on it a while back and I'm going to just dispose of the remaining half gallon or so I have left after hearing what my local waste management people have to say. I've had someone else tell me to "cook it into a puck and then recycle it". Problem being that it burns before it hits 350, so it's not going to get that reaction. Also I'm not sure if it's recyclable in the first place. Quote Link to comment Share on other sites More sharing options...
Chris Catignani Posted Tuesday at 04:37 AM Report Share Posted Tuesday at 04:37 AM You could always try cutting it in with a more suitable plastisol at something like 4:1 or something. This is how I got rid of some I had that was not really what I wanted. Quote Link to comment Share on other sites More sharing options...
Les Young Posted Wednesday at 12:33 AM Report Share Posted Wednesday at 12:33 AM I'd mix it in a little at a time with whatever plastisol you're using now. Quote Link to comment Share on other sites More sharing options...
mark poulson Posted Wednesday at 03:14 AM Report Share Posted Wednesday at 03:14 AM Did you contact Bait Plastics? Quote Link to comment Share on other sites More sharing options...
Psy Posted Wednesday at 05:33 AM Author Report Share Posted Wednesday at 05:33 AM 2 hours ago, mark poulson said: Did you contact Bait Plastics? I didn't get a reply when I tried their CSR email. Had to check my account to see when the purchase was made, it's been a while. Got it in June. I'm not slamming Bait Plastics here either, I know plenty of people that swear by their products. Quote Link to comment Share on other sites More sharing options...
Bass-Boys Posted Wednesday at 01:25 PM Report Share Posted Wednesday at 01:25 PM (edited) Add heat stabilizer and use it mixed in like mentioned above. but if it messes up your new plastisol - pitch it out Edited Wednesday at 01:26 PM by Bass-Boys added more info Quote Link to comment Share on other sites More sharing options...
