finlander Posted March 5, 2005 Report Share Posted March 5, 2005 Does all luremaking glue/cement smell that bad? Nail polish is that bad too. Anyone use something that you can use indoors?? Thanks in advance. Quote Link to comment Share on other sites More sharing options...
TRIPLE C CUSTOM LURES Posted March 5, 2005 Report Share Posted March 5, 2005 What are you trying to glue on eyes i use krazy glue with a clear top coat, works well. Quote Link to comment Share on other sites More sharing options...
finlander Posted March 5, 2005 Author Report Share Posted March 5, 2005 I am just putting bucktail on spinners and spinnerbaits. I have it setup out in the hallway. I own two parrots, and what might smell obnoxious to us might kill them. Not warm enough to do outside yet, and the basement is cold. I would like to find something that I could use inside without setting up a fan that would pull all the heat out. Quote Link to comment Share on other sites More sharing options...
Richoc Posted March 5, 2005 Report Share Posted March 5, 2005 Are you talking about head cement? You can use epoxy if you would like. Quote Link to comment Share on other sites More sharing options...
TRIPLE C CUSTOM LURES Posted March 5, 2005 Report Share Posted March 5, 2005 I use epoxy. You should try it. works great. Quote Link to comment Share on other sites More sharing options...
finlander Posted March 5, 2005 Author Report Share Posted March 5, 2005 I've used a 2-ton epoxy when anchoring screw eyes in body baits. It is a two part epoxy that smells worse than anything I have used in the past. What epoxy do you use? One other question. I am trying to have the hair 'flare out' on my spinnerbait. The collar area is very short. Not alot of room to ty anything there. Originally there was a rubber skirt there. What technique is employed to flair out the hair? Thanks again. the Rookie Quote Link to comment Share on other sites More sharing options...
VARick Posted March 6, 2005 Report Share Posted March 6, 2005 You might tie a reverse tie (or backwards tie) with bucktail.. you will need a little room to that tho. You can see a recipe for this at the following link http://www.aswf.org/saltwater_flies_for_web/bob_popovics/saltwater_flies_bob_hollow.html The flare can be controlled with tension after pushing the bucktail back towards the rear. Hope this helps. Rick I've used a 2-ton epoxy when anchoring screw eyes in body baits. It is a two part epoxy that smells worse than anything I have used in the past. What epoxy do you use? One other question. I am trying to have the hair 'flare out' on my spinnerbait. The collar area is very short. Not alot of room to ty anything there. Originally there was a rubber skirt there. What technique is employed to flair out the hair? Thanks again. the Rookie Quote Link to comment Share on other sites More sharing options...
