Joe Martin Posted March 21, 2005 Report Share Posted March 21, 2005 I am currently making, or at least trying, to make some super strike style poppers. I have the turning down and have a 65 degree angle on the face. My question is how do I scoop out the the face? Thanks in advance for any help. JM ( new guy) Quote Link to comment Share on other sites More sharing options...
cheesehead Posted March 21, 2005 Report Share Posted March 21, 2005 Joe, Check out the user tutorials section there is plenty of info to get you going in the right direction. Here is a link that will answer your question. http://www.tackleunderground.com/index.php?page=10&mode=article&k=7 Quote Link to comment Share on other sites More sharing options...
apb Posted March 22, 2005 Report Share Posted March 22, 2005 I set up a jig on my drill press that holds the plug verticle. Use a half round router bit to do the cup. You might also be able to find a ball rasp to do this. Andrew Quote Link to comment Share on other sites More sharing options...
mossy maker Posted March 22, 2005 Report Share Posted March 22, 2005 I use a Dremel tool with a small sanding drum. mossy maker Quote Link to comment Share on other sites More sharing options...
Lure--Prof Posted March 22, 2005 Report Share Posted March 22, 2005 I use a Dremel with a carbide burr to rough it out. then a sanding drum, a round grinding stone, and do final touch-up by hand with a bit of sandpaper. Dean Quote Link to comment Share on other sites More sharing options...
kellure Posted March 22, 2005 Report Share Posted March 22, 2005 I do the same as Dean, dremel w/ a round grinding bit, then follow up with sandpaper. Quote Link to comment Share on other sites More sharing options...
Terrydabassman Posted March 24, 2005 Report Share Posted March 24, 2005 Here ya go, http://www.blackstoneind.com/ordermaxx/foundations/store/scresults.asp?name=Typhoon+Carbide+1%2F4+in&category=146 Quote Link to comment Share on other sites More sharing options...
