Jarron Posted January 9, 2006 Report Share Posted January 9, 2006 Hello, I need about 200 of these "bent up". Any idea who can do this for me at a good price? The overall legnth will be about 10" and using .073 stainless or close to it. Thanks, Jarron Quote Link to comment Share on other sites More sharing options...
cheesehead Posted January 9, 2006 Report Share Posted January 9, 2006 Have you considered bending them yourself? There is a couple of ways to go about it. #1 would be to get apair of round nosed pliers (sears sells them) and just bend the wire. #2 the other way is to make a form by drilling holes into a block of wood and inserting nails or rollpins at each bend point. then just wrap your wire around each pin. Quote Link to comment Share on other sites More sharing options...
Jarron Posted January 11, 2006 Author Report Share Posted January 11, 2006 Thanks for the reply... I would rather pay someone to do them for me. Although I only need 200 as a prototype now, my required quantity will be much, much higher. I was hoping someone know of someone that may have a machine that dose this. Since I will need a "bunch" of these, bending by hand or making a jig would not be a good idea in the long run. But until I find someone to do this for me, the bolt and block method is what I will do. Thanks! Jarron Quote Link to comment Share on other sites More sharing options...
jaime Posted January 11, 2006 Report Share Posted January 11, 2006 yeah that's alot of bending. would be nice to have a machine do the work. Quote Link to comment Share on other sites More sharing options...
