CrawChuck Posted February 26, 2006 Report Share Posted February 26, 2006 Anybody ever use this stuff? http://www.zerodproducts.com/page4.html Edited to say...Probably not since I got a reply from them regarding prices... AKRON RTV-RP SILICONE RP Clear / RP White One Hour Cure time 1.1 lb. Kit $37.55 / 39.55 2.2 lb. Kit 58.40 / 61.90 8.8 lb. Kit 193.80 / 207.80 44 lb. Kit 587.00 / 657.00 .26 lb. Bottle extra catalyst 16.00 1.0 lb. Bottle extra catalyst 50.00 Maybe when I get rich...would be cool to have clear molds though Quote Link to comment Share on other sites More sharing options...
jm Posted February 27, 2006 Report Share Posted February 27, 2006 I use silicones inc stuff. I think I ususally use gl1000. It's available from industrial arts supply type places for about $35 per quart or so. The less expensive, common type is condensation cure. (I think tin activated) It pours very slow, will fill any gap, and makes a permanent mold for sure. It has a limited shelf life, and gets very thick if you open it up and look at it too many times. http://www.silicones-inc.com/conden.htm hope it helps, jm Quote Link to comment Share on other sites More sharing options...
robbor Posted February 28, 2006 Report Share Posted February 28, 2006 but I have been looking and for plastic worms(low temp) almost any should work. I found some that cost about $20 for 1 pound. Contenti has rtv and check smooth-on, or call them and ask for your application Quote Link to comment Share on other sites More sharing options...
jm Posted February 28, 2006 Report Share Posted February 28, 2006 a quart is a couple of pounds. jm Quote Link to comment Share on other sites More sharing options...
