kbkindle Posted March 27, 2006 Report Share Posted March 27, 2006 coley kbkindle here copeyed your info on making your own bills understand about all except where you put eye after you bend wire and into hole in bill do you glue it to bill also i assume after wire is bent and goes under bill to back of bill the wire is exposed and then glue with bill to bait. kb thanks Quote Link to comment Share on other sites More sharing options...
Coley Posted March 28, 2006 Report Share Posted March 28, 2006 Look at the pictures close. The wire is not glued to the lip. At the rear end of the lip I cut a notch, the wire folds up over this notch. Then the lip is epoxied into the bait. This is the only place any glue is applied to the wire. DONOT GLUE THE WIRE TO THE LIP ANYWHERE, IT WON'T HOLD. And it will only make a mess of your lip. Coley Quote Link to comment Share on other sites More sharing options...
kbkindle Posted March 28, 2006 Author Report Share Posted March 28, 2006 kb thank again some times ia'm a little dumb but i just want to get it correct thanks kb Quote Link to comment Share on other sites More sharing options...
