bamabass Posted February 4, 2007 Report Share Posted February 4, 2007 Ok im new to this so I might ask dumb questions but I know you guys will help.When i make my mold say,for a DD22,how would i make the cut in the front for my lexan lip?Is the foam cutable or do I have to mold the rtv to make a slot for the lip? Thanks! Quote Link to comment Share on other sites More sharing options...
Husky Posted February 4, 2007 Report Share Posted February 4, 2007 Ok im new to this so I might ask dumb questions but I know you guys will help.When i make my mold say,for a DD22,how would i make the cut in the front for my lexan lip?Is the foam cutable or do I have to mold the rtv to make a slot for the lip?Thanks! Either way will work. Just use a good Mold Release if you cast the slot into the mold. 16 lb density foam cuts like wood. You might want to try putting a thin line where the cut is to go on your model. That'll give your mold an exact cutting reference, in any event. What's DD22? Quote Link to comment Share on other sites More sharing options...
bamabass Posted February 4, 2007 Author Report Share Posted February 4, 2007 A Norman DD22 is what us deep fisherman use.Its a crankbait that runs about 18'. http://www.normanlures.com/nlstore/Detail.asp?DBID=10&CatID=1&SubCatID=4&Prod_Id=DD22 Quote Link to comment Share on other sites More sharing options...
