dhubb Posted February 12, 2007 Report Share Posted February 12, 2007 I have the Bob's stick molds(senko) and would like to pour a couple of laminate colors. How would I go about doing this being these are 2pc molds that make a round bait? I tried pouring both colors at the same time but ended up with a blended bait instead of two seperate colors. Quote Link to comment Share on other sites More sharing options...
Dungeonhawk Posted February 12, 2007 Report Share Posted February 12, 2007 open the mold, pour half the bait with one color, close it up, pour the other. make sure the 2nd plastic is very hot so you get a good bond. Quote Link to comment Share on other sites More sharing options...
dhubb Posted February 12, 2007 Author Report Share Posted February 12, 2007 I'll try that thanks! Quote Link to comment Share on other sites More sharing options...
SwampBaits Posted February 12, 2007 Report Share Posted February 12, 2007 You might also want to preheat your mold. If I do any sorta multi pour with aluminum I always preheat my mold to at least 150 degrees. It helps prevent cold cracks, which are a common occurance with aluminum molds. Quote Link to comment Share on other sites More sharing options...
BBC Posted February 13, 2007 Report Share Posted February 13, 2007 Also, how big is the bait??? The 4" baits are harder to do. If you can, start with the 5" until you get used to it. I started with the 4" and had only got 6 or 7 out of 10 to turn out right until I got used to it (which took a few months. Quote Link to comment Share on other sites More sharing options...
BassnG3 Posted February 13, 2007 Report Share Posted February 13, 2007 Another thing is if you screw one up just pull apart and reheat the plastic and try again. Scott Quote Link to comment Share on other sites More sharing options...
