RiverMan Posted March 3, 2007 Report Share Posted March 3, 2007 Anyone doing this? I want to try a new brush for applying the etex and want to make sure I have a way to clean it out after I'm done. I did a search on the topic and found guys were using denatured alcohol and acetone with Devcon and wondered how either of these products worked on etex. Thanks guys. RM Quote Link to comment Share on other sites More sharing options...
Lure--Prof Posted March 3, 2007 Report Share Posted March 3, 2007 I squeezee out the excess with a rag and then dab the brush in a puddle of alcohol. Next I dab it about in another puddle until the brush appears clean. Then I clean it with a little dish soap in the kitchen and rinse thoroughly. Acetone works also, but the alcohol is a bit nicer to the nostrils. Dean Quote Link to comment Share on other sites More sharing options...
RiverMan Posted March 3, 2007 Author Report Share Posted March 3, 2007 thx Dean Quote Link to comment Share on other sites More sharing options...
philB Posted March 3, 2007 Report Share Posted March 3, 2007 Hi Riverman I use Ethyl Acetate. Not to everyones liking though as it is an extreme solvent and care should be taken when using it but it is truly the best cleaner. philB Quote Link to comment Share on other sites More sharing options...
woodieb8 Posted March 3, 2007 Report Share Posted March 3, 2007 after using brush i put brush in a bottle of lacquer thinners. blow it out with compresser and re-use.. no chunks or problems Quote Link to comment Share on other sites More sharing options...
RiverMan Posted March 3, 2007 Author Report Share Posted March 3, 2007 Hmmm, ok....will give a couple options a try today. thx again. jed v. Quote Link to comment Share on other sites More sharing options...
