akriverrat Posted March 21, 2007 Report Share Posted March 21, 2007 this high temp tape that is used for powder coating i am assuming that it is for masking areas that dont get a coating but i am wondering if you can fully cure a base coat and then mask a design, heat and redip in another color? does anyone have experiance with this or am i getting my hopes up too much? thanks. john Quote Link to comment Share on other sites More sharing options...
LedHed Posted March 21, 2007 Report Share Posted March 21, 2007 John You will be softening or melting your basecoat, under the masking, when you re-heat the jig. It would probably be easier to cut stencils out of clear plastic (so you can see what you are doing). Don Quote Link to comment Share on other sites More sharing options...
