Guest Anonymous Posted October 6, 2003 Report Share Posted October 6, 2003 What do you think? Seem to work pretty good. Quote Link to comment Share on other sites More sharing options...
Celticav Posted October 6, 2003 Report Share Posted October 6, 2003 Nice job, what weight is it? JIM Quote Link to comment Share on other sites More sharing options...
Guest Anonymous Posted October 6, 2003 Report Share Posted October 6, 2003 1/8 th......thanks for the reply....I am wanting to start bending my wire differently. Are there any benders or forms available? See example of the bend I want to make below. Thanks Again. Chip Quote Link to comment Share on other sites More sharing options...
Celticav Posted October 6, 2003 Report Share Posted October 6, 2003 If you just want to make R- bends like the one pictured I would recommend the Lil' Blue Bender from Stamina or Barlow's, Its good for making the swivel loops too, JIM Quote Link to comment Share on other sites More sharing options...
Guest Anonymous Posted October 6, 2003 Report Share Posted October 6, 2003 I've been making in-lines for years....Not to many bends..... But I wanted to start making some cast bucktails and skirted spinners/buzzes. More of a wire bending and wire angle science than in-lines. I'll look up the bender you recommended...Thanks Quote Link to comment Share on other sites More sharing options...
MrTimster Posted October 14, 2003 Report Share Posted October 14, 2003 Those are some fine looking jigs. Quote Link to comment Share on other sites More sharing options...
