snooterfish Posted May 3, 2007 Report Share Posted May 3, 2007 guys i need to (want too) put a larger blade on a Buzz Bait, i don't have any Spinnerbait tools, can i do this without the wire benders? if so would someone care to explain it to me. snooterfish Quote Link to comment Share on other sites More sharing options...
dampeoples Posted May 3, 2007 Report Share Posted May 3, 2007 You have an existing buzzbait, I assume? bend the wire straight on the end of the shaft, take the rivet, any beads and the old blade off, slide a new one on, then the rivet, and bend the tip back down. If the blade is so large that it will hit the head, not a bad thing, unless it won't spin freely, then nail two nails in a board, and rebend it to fit. Be careful though, might break the wire if you bend too far/much. Quote Link to comment Share on other sites More sharing options...
snooterfish Posted May 3, 2007 Author Report Share Posted May 3, 2007 Thanks dampeoples, i apreciate the help. snooterfish Quote Link to comment Share on other sites More sharing options...
