Guest Anonymous Posted October 23, 2003 Report Share Posted October 23, 2003 I finally finished. I am pleased with the results. http://carolinachip.home.att.net/how_to_make_wooden_crank_baits.htm Take Care All! Quote Link to comment Share on other sites More sharing options...
Coley Posted October 23, 2003 Report Share Posted October 23, 2003 Very nice job!! Please tell me how you cut the lip slot and keep it horinzontally level with the bait??? Coley Quote Link to comment Share on other sites More sharing options...
Guest Anonymous Posted October 23, 2003 Report Share Posted October 23, 2003 Thanks for askin....I use a dremel tool attached to a dremel drill press. I machined a stationary slide tray on a mill. I attached the guide to the dremel press plate and I have a small vice with very soft silicon rubber grips attached to the guide. I use an angle guide to get the degree setting correct, set the lure in the grips, and mill it vertically and then side to side until complete. Might sound like a crazy way, but it works well. The lip will generally fit in like a puzzle piece and with some 5 min epoxy, its set. Quote Link to comment Share on other sites More sharing options...
blackjack Posted October 24, 2003 Report Share Posted October 24, 2003 Keep up the good work!! Quote Link to comment Share on other sites More sharing options...
